Same as above but you can assign that Wall Covering to the entire room.ĥ. You can assign a Wall Covering to the wall that is the same material as your interior wall finish and covering the entire wall.Ĥ. If it's not at an outside corner you can place a break and do the same as above.ģ. This drywall edge will then produce a line.Ģ. If it happens at an outside corner, use the Edit Wall Layer Intersections tool to drag the drywall layer on the wall being viewed back so that its not being flush with the inside face of the adjacent wall and not being beveled or tucked behind. There are a few workarounds that might hold you over until Chief fixes the issue.ġ. In the meantime, it looks like the problem is that the program needs a defined edge there in order to draw anything. I would recommend you report this to tech support. They aren't working the same as they used to and I can easily reproduce your issue. I never actually use wall elevation cameras so I hadn't noticed this problem before but you appear to be absolutely correct.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |